Dual Axis Tracker Assembly Guide

  1. Start by attaching one of the Servos to the center ring.
    • Start by attaching one of the Servos to the center ring.

    • Use the two screws inside the Servo bag.

    • Attach the servo to the bottom, which is the side without any etching.

  2. Screw each of the four legs into the center ring.
    • Screw each of the four legs into the center ring.

  3. Screw the second Servo into the the mount.
    • Screw the second Servo into the the mount.

    • Combine the wooden parts as shown to build the center section of the tracker.

  4. Using two of the very small screws, attach a Servo Horn to the bottom of the circular wooden piece.
    • Using two of the very small screws, attach a Servo Horn to the bottom of the circular wooden piece.

    • Use either the four prong Servo Horn or two prong Servo horn.

    • Only use two screws. You need the other two for the second Servo.